Jig is stiff
Hello, using my new T8 for the first time. Moving the SE 77 from side to side is really hard work. Is there anything wrong or should I clean or lubricant the universal support bar?
Follow this post
1
followers
Hi Neil.
Do not lubricate anything. Keep it clean and dry.
We have tight tolerances between the jigg bushings and universal support.
In your case it seems like it is a little too tight.
You can open up the busing to fit your universal support.
Start by centering the jig (lines parallel).
Then you remove the universal support and carefully push the treaded leg on the universal support through the bushings in the SE-77. Move it back and forth a few times and you will open up the bushings enough to get a perfect fit between the jig and universal support.
Good luck.
.